HWIC-2CE1T1-PRI Specification

Description

2 port channelized T1/E1, and PRI HWIC (data only) Cisco Router High-Speed WAN Interface card

Diagnostic Loopback Support

• E1 loopback modes:

• Controller local loopback

• Interface local loopback

• T1 loopback modes:

• Interface local loopback

• Interface remote loopback

• Controller local loopback

• Controller remote loopback

• CSU loopback modes for T1 CSU:

• Data terminal equipment (DTE) loopback

• Network loopback

• Payload loopback

Alarm Detection

• Yellow Alarm-Receive/Send from/to network

• Blue Alarm-Receive alarm indication signal (AIS) from network

• Red Alarm-Loss of network signal

Relevant MIB Support

• T1 MIB (RFC1406-MIB)

• Cisco Integrated DSU/CSU MIB (CISCO-ICSUDSU-MIB)

Remote Management

• Cisco CNS 2100 Series Intelligence Engine (IE2100)

• CiscoWorks

Signaling Debugging

• ISDN Q.921 and Q.931 decode

• All other previously existing applicable Cisco IOS Software debugs

Dimensions (H x W x D)

• HWIC-2CE1T1-PRI: 0.75 x 3.08 X 4.74 in.

• (1.91 x 7.82 x 12.04 cm)

Weight

• HWIC-2CE1T1-PRI: 0.19 lb (0.09 kg)

Operating Temperature

• 32 to 104°F (0 to 40°C)

Nonoperating Temperature

• -40 to 158° F (-40 to 70°C)

Relative Humidity

• 5-95% noncondensing

LEDs

LEDs per port

• Carrier Detect/Loopback (CD/LP):

• Off = No carrier detect

• Green On = Carrier detect

• Yellow On = Port in loopback mode

• Alarm (AL):

• Off = No alarms

• Yellow On = Port in alarm mode

LEDs per module (on NM-8CE1T1-PRI only):

• EN:

• Off = Card not available

• On = Card enabled

Ports

• 1, 2, or 8 T1/E1 ports on RJ-48C connectors

Line Bit Rate (per Port)

• E1: (2.048 Mbps)

• T1: (1.544 Mbps)

Line Coding

• E1: High-density bipolar three (HDB3 )

• T1: Alternate mark inversion (AMI) and binary 8-zero substitution (B8ZS

Framing Formats

• E1: CRC4

• T1: Super Frame (SF) and Extended Super Frame (ESF)

Output Levels

• E1: short-haul/long-haul

• T1 (line build-out [LBO]): 0, -7.5, or -15 dB